£24.95
Acid Etch Solution is a pre-treatment for concrete power floated or very smooth concrete
floors. The Acid Etch Solution opens the pores of the concrete and prepares the surface to
accept its next treatment, allowing excellent adhesion.
Apply evenly by soft brush or broom and leave for approximately 15 minutes or until it ceases
to bubble and fizz. Rinse with clean water after reaction is completed and leave 24hrs to allow
the floor to dry completely before painting.
Area of use:
Interior or Exterior
Substrates:
Concrete
Packing:
5 Litres
Physical Constants:
Colour: Clear
Finish: –
Volume solids: –
Theoretical spreading rate: Approx. 20 sq. metres per litre
Flash point: –
Specific gravity: 1.1
Dry to touch: 2-4 hours
Over-coating time: 1-2 days
*The theoretical spreading rate has been calculated for the stated volume solids and dry film
thickness. A practical spreading rate will depend on the actual dry film thickness, the nature of the
substrate, and the relevant consumption factor. The physical constants are subject to normal
manufacturing tolerances.
Application Details:
Application method: Brush / Mop / Broom
Thinner: N/A
Cleaning of tools: Water
Surface Condition:
Ensure surface is free from dust and debris. Excess dirt, oil or
grease should be scrapped off or removed.
Please refer to the Material Safety Data Sheet for further information. For additional guidance please contact us here
Whether you need expert advice on surface preparation techniques, or application tips, our team is always here to help!
Your ultimate destination for all your painting and finishing needs.
© 2024 All Rights Reserved.
Reviews
There are no reviews yet.